Web Site
     
      
 
 
 
 Circuit / Schematic diagram of  Description
10Mhz Video Amplifier Based on MAX4135 video amplifier chip
Video Signal Amplifier The circuit uses five transistors and is a broad band amplifier with a bandwidth of 5 MHz.
Video Amplifier One transistor based simple video Amplifier
Video Amplifier with sync stripper and DC The circuit in Figure 1 transmits 200MHz (-3dB bandwidth) video signals while stripping off the sync pulse and performing DC restoration.
OpAmp based Video Amplifier Amplifier with 40dB gain and 10MHz bandwidth.
OpAmp based Video Amplifier 2 Based on LH0032 IC
Simple Video Amplifier Video signal amplifier circuit using BJT
Simple Video Amplifier 2 Similar circuit as previous, based on BJT
TV Signal Amplifier Single transistor based capable on working on frequency of 1.6 GHz
UHF Preamplifier Amplifies signal in the range 450-800Mhz and gain of the circuit is 10dB. Suitable for boosting week UHF video signal.
Video amplifier 1  
Video distribution amplifier Op-Amp based circuit and has three output terminal
Video distribution amplifier 2 Uses CA3100 and amplifies signal with low noise and without loss
Video signal amplifier Video amplifier with high bandwidth and based on LH0032
Video signal amplifier 2 Range is from 1-20Mhz and based on LM359N
Video amplifier Based on 404 operational amplifier
Non Inverting Video amplifier Transistor based circuit also contains other arrangements.
   
   
   
   
 
Help Center
Contact help center if you need help with electronic designs like circuit, PCB etc.
 
Guestbook
Post message regarding your queries and suggestions.

View this page in your language
 
© Copyright Diwakar Bista. || This site is best viewed on 1024x768 resolution